Rockler Center/Offset Marking Tool Kreg Tool Table Height From Floor: 34″

Table Height From Floor: 34″

or for making reference lines for drilling holes

For use with 1/2" to 11/2" thick material

2 square feet of polyester spun bond pleated filter to ensure maximum airflow

Rockler Center/Offset Marking Tool Kreg Tool Table Height From Floor: 34″Straddles your board to mark a perfectly centered line, or you can use the notches to mark offset lines from 1 16'' to 1 2'' from the edge in 1 16'' increments. Our Center Offset Marking Tool straddles your board to mark a perfectly centered line along the face or edge of boards up to 1 1 2'' wide or thick. Just insert your pencil into the center hole, rotate the tool so the guide posts contact the material, then scribe. Alternatively, you can use a